NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

Chapter 6 111

Point-to-Point (Router) Network Interface Conﬁguration Screens

Protocol Conﬁguration

The Protocol Conﬁguration screen (#113) in Figure 6-4 is displayed

when you press the

[Go To PROTOCOL] function key at the

Point-to-Point Network Interface Conﬁguration screen (Figure 6-3). It

is also displayed when you type the path name:

@NETXPORT.NI.NIname.PROTOCOL

in the Command window of any screen and press the [Enter] key, where

NIname is a conﬁgured point-to-point (router) NI name.

Figure 6-4 Protocol Conﬁguration Screen

For a point-to-point NI, you must conﬁgure the IP protocol. The Dial

protocol must be conﬁgured if you have switched lines.

Choose the protocol to conﬁgure and press the corresponding function

key.