NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

Chapter 6 117
Point-to-Point (Router) Network Interface Configuration Screens
Dial ID Protocol Configuration
When a dial connection is initiated by a remote node,
the security string sent by the remote node is checked
against the list of valid security strings configured for
the dial ID protocol for this network interface. (See
“Related screens”). When a dial connection is initiated
by this node, the local dial ID protocol sends the
destination’s security string (as configured on this
node) to that node.
If security validation fails, an error message is logged,
where PARM indicates if the failure was local or remote.
(See the NS 3000/iX Error Messages Reference Manual
for a description of any error message received.)
Related screens:
• NETXPORT.NI.NIname.PROTOCOL.DIAL.SECURITY
Security strings valid for this network are
configured in this screen.
• NETXPORT.NI.NIname.MAPPING.mapentry
The remote node’s security string is configured in
this screen.
Default value: Y
Range: Y or N