NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

124 Chapter6
Point-to-Point (Router) Network Interface Configuration Screens
Direct Connect Link Configuration
Fields Start device on network initialization (Y/N)
A Y (Yes) value means that the device is to begin
startup when a NETCONTROL START command is issued
for the network interface being configured. The
physical layer is activated when NETCONTROL START is
issued, but the data link layer on the first remote device
is not activated until the first REMOTE HELLO using that
device is issued. An N (No) means that a NETCONTROL
ADDLINK command must be used to start the device. For
more information on these commands, refer to the
NS 3000/iX Operations and Maintenance Reference
Manual.
Default value: Y
Range: Y or N
Enable idle device timer (Y/N)
This field specifies whether the device is to be
disconnected automatically if no packets have been
received or transmitted over the link during a specified
time period. This field is relevant only if a timeout
value has been entered in the network interface screen
as listed.
Related screen:
• NETXPORT.NI.NIname
The idle device timeout value is configured on this
screen.
Default value: N
Range: Y or N