NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

Chapter 6 131
Point-to-Point (Router) Network Interface Configuration Screens
Neighbor Gateway Reachable Networks
Press the [Save Data] function key to transfer the data displayed on the
screen to the configuration file you are creating or updating. Verify that
the data record has been created by checking that the Data flag is set
to Y.
NOTE The information configured in this screen can extend to more than one
page, if necessary, to allow configuration of up to 2550 reachable
networks per link (255 pages and 10 reachable nets per page). Press
[Next Page] to proceed to a new page. Press [Prev Page] to display a prior
page. Use
[First Page] to display the first page (for example, if you are
viewing the third page, pressing
[First Page] will immediately display
the first page). Press
[Last Page] to display the last page of reachable
networks that has been configured. To consolidate reachable networks
entries (from several pages, for example) press [Condense Page].
Fields Neighbor gateway IP internet address
Enter the full network address of a gateway node (on
this network) that is to be used to reach other networks
(any network in the same internetwork other than the
network of which this node is a member). The network
portion of the address must be the same as that entered
on the IP Protocol Configuration screen for the network
interface you are configuring (see “Related screens”).
There are two methods of entering an internet protocol
(IP) address within NMMGR:
1. Enter the fully qualified IP address (for example,
Class C, C 192.191.191 009)
OR
2. Enter only the network (nnn) and node (xxx)
portions of the IP address as four positive integers
between 0 and 255 separated by periods or blanks
(for example, 15.123.44.98).
You need not enter the following items as NMMGR
will fill these in:
– Class A, B, C
– Leading zeros for the network and node portion of
the IP address.