NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

142 Chapter6
Point-to-Point (Router) Network Interface Configuration Screens
Point-to-Point Reachable Nodes
D One second delay (used for European
modems and automatic call units that
require built-in delays).
# Defined by local phone system.
* Defined by local phone system.
Enter ! to disable outbound dialing. A ! is required if
the destination node is a personal computer.
You can have 4096 unique phone numbers in your
NM configuration file.
Default value: None
Security String
This is the security string of the destination node. It is
relevant only if all of the following are true: the
destination is local, the link is a dial link, DIAL ID
protocol is enabled, and security is enabled. It is
ignored when security is not enabled at the local node.
The security string can contain as many as eight
alphanumeric characters. It must be left justified and
contain no embedded blanks.
Related screens:
• NETXPORT.NI.NIname.LINK.linkname
Dial ID protocol is enabled/disabled on this screen.
• NETXPORT.NI.NIname.PROTOCOL.DIAL
Security validation is enabled/disabled on this
screen.
Default value: HP
Next hop IP internet address
This parameter specifies the correct path for a message
to take when there is more than a single hop between
the sending node and the destination.
Default value: None
Route disabled (Y/N)
Use this field to disable routing to the remote node.
Disabling routing might be useful if you are testing
another link and want to temporarily disable this one.
Default value: N
Range: Y or N