NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

170 Chapter7

X.25 Network Interface Conﬁguration Screens

Neighbor Gateway Reachable Networks

The Neighbor Gateway Reachable Networks screen (#158) in Figure

7-14 is displayed when you select a gateway name at the Neighbor

Gateways screen (Figure 7-13) and press the

[Add] or [Modify] function

key. It is also displayed when you type the path name:

@NETXPORT.NI.NIname.INTERNET.gatewayn

in the command window of any screen and press the

[Enter] key, where

NIname is a conﬁgured X.25 NI, and gatewayn is the conﬁgured X.25

NI gateway name.

Figure 7-14 Neighbor Gateways Reachable Networks Screen

Press the

[Save Data] function key to transfer the data displayed on the

screen to the conﬁguration ﬁle you are creating or updating. Verify that

the data record has been created by checking that the Data ﬂag is set

to Y.

NOTE The information conﬁgured in this screen can extend to more than one

page, if necessary, to allow conﬁguration of up to 2550 reachable

networks per link (255 pages and 10 reachable nets per page). Press

[Next Page] to proceed to a new page. Press [Prev Page] to display a prior

page. Use

[First Page] to display the ﬁrst page (for example, if you are

viewing the third page, pressing

[First Page] will immediately display

the ﬁrst page). Press

[Last Page] to display the last page of reachable

networks that has been conﬁgured. To consolidate reachable networks

entries (from several pages, for example) press [Condense Page].