NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

278 Chapter13
Network Directory
Network Directory Data
then checksums are used when
communicating with this node.
Checksumming is required for
communicationtonon-HP systems.The
default is N.
PXP PXP must be Y (yes) for all nodes. The
default is Y.
Note that the selection of transport services here must
match the settings in the remote node’s configuration
file. If the checksum enabled field in the path
NETXPORT.GPROT.TCP of this node is set to Y, then TCP
checksum field in the network directory should also be
set to Y.
IP Address One IP address should be entered for each network
interface configured on the remote node that is directly
reachable from this node. Each address must match an
IP address configured in the remote node’s
configuration file. The path of the screen in the
configuration file that contains IP addresses is
NETXPORT.NI.NIname.PROTOCOL.IP.
Type A number indicating the type of path to configure is
shown in Table 13-1:
1 Select this path type when the NI type
is ROUTER (point-to-point); or when the
NI type is LAN and the destination node
supports probe or ARP; or when the NI
type is TOKEN or FDDI and the
destination node supports ARP.
2 Select this path type when the NI type
is LAN, the destination node does not
support probe, and 802.3 framing is
used.
3 Select this path type when the NI type
is X25.
4 Select this path type when the NI type
is LAN, the destination node does not
support ARP, and Ethernet framing is
to be used.
5 Select this path type when the NI type
is TOKEN and the destination node does
not support ARP.
6 Select this path type when the NI type
is FDDI and the destination node does
not support ARP.