NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

58 Chapter3
Link Configuration Screens
100Base-T Link Configuration
100Base-T Link Configuration
The 100Base-T Link Configuration screen (#306) in Figure 3-9 is
displayed when you select a link name of type BT100 at the Link
Selection screen (Figure 3-2) and press the
[Add] or [Modify] function
key. It is also displayed when you type the path name:
@LINK.linkname
in the command window of any screen and press the
[Enter] key, where
linkname is the name of a configured BT100 link.
Figure 3-9 100BaseT Link Configuration Screen
Press the
[Save Data] function key to transfer the data displayed on the
screen to the configuration file you are creating or updating. Verify that
the data record has been created by checking that the Data flag is set
to Y.
Fields Physical path of device adapter
The physical path number corresponds to the I/O slot
where the 100Base-T (BT100) network interface card is
installed. Each hardware platform has a specific format
and designation for the physical path. Refer to
Appendix E, “Verifying Attached Devices” in the System
Startup, Configuration, and Shutdown Reference
Manual for the procedure on how to determine the
physical paths of I/O cards installed in the system.