NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

60 Chapter3
Link Configuration Screens
100Base-T Link Configuration
Trace at startup?:
Enter Y (YES) to enable link tracing, N (NO) otherwise.
This value can be overridden with the LINKCONTROL
command. If enable link tracing is selected, a trace file
name is required.
For best performance, do not enable tracing.
Default value: N
Trace filename:
Required if link trace is enabled. Name of the disk file
where you want to record tracing. Must be a valid MPE
file name. Enter the file name in the format
filename.groupname.acctname. The fully qualified
file name can be as many as 26 characters.
Lockwords are not allowed for trace files.
Do not specify the same file name with the NMMGR
configuration as specified with the LINKCONTROL
command. Only one active trace is allowed per link.