NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

62 Chapter3
Link Configuration Screens
VG100LAN Link Configuration
Use factory-configured local station address?
(HP modifiable.)
Y Indicates that the factory-configured
local station address is to be used.
N Indicate that a new value should be
used as the local station address. Do
not change the factory-configured
address except on the specific
instructions of your network
administrator or your Hewlett-Packard
representative.
Default value: Y
Local station address
(HP modifiable.) Specifies the new local station
address if the address is being changed. Your HP
support representative will supply instructions for
what to enter.
Link speed
This field is used to determine the mode with which the
card will communicate.
Default value: 100
Full Duplex mode
If auto-negotiation is turned of, then this field is used to
determine the mode with which the card will
communicate.
Default value: N=Half
Trace at startup?:
Enter Y (YES) to enable link tracing, N (NO) otherwise.
This value can be overridden with the LINKCONTROL
command. If enable link tracing is selected, a trace file
name is required.
For best performance, do not enable tracing.
Default value: N
Trace file name:
Required if link trace is enabled. Name of the disk file
where you want to record tracing. Must be a valid MPE
file name. Enter the file name in the format
filename.groupname.acctname. The fully qualified
file name can be as many as 26 characters.