NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

66 Chapter4
Network Transport Configuration Screens
The Network Transport Configuration Selection screen allows you to
define global parameters for the node as well as network interfaces of
type LAN, ROUTER (point-to-point), X.25, SNA, TOKEN (Token Ring),
FDDI, 100VG-AnyLAN, 100Base-T, Gateway Half, or Loopback.
To reach the network transport configuration screens, run NMMGR,
and refer to the following pages of this section for a step-by-step
process.
Step-by-Step Process:
Step 1. Run NMMGR. The Open Configuration/Directory File screen is
displayed.
Step 2. Enter the configuration file name (NMCONFIG.PUB.SYS) and password, if
a password is required, and press the
[Open Config] function key. If you
have not yet created the configuration file you will need to press the key
a second time. The Main screen is displayed.
Step 3. Press the
[NS] function key. The NS Configuration screen is displayed.
Step 4. Press the
[Unguided Config] function key. The Unguided Configuration
screen is displayed.
Step 5. Press the
[Go To NETXPORT] function key and the Network Transport
Configuration Selection screen is displayed.
For more general information on NMMGR, refer to Using the Node
Management Services (NMS) Utilities.
NOTE Fields described as “HP modifiable” should be changed only upon the
recommendation of your Hewlett-Packard representative.