NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

88 Chapter5
LAN Network Interface Configuration Screens
LAN Network Interface Configuration
enter these nodes into the network directory and set
load network directory mapping to Y.
HP recommends the default unless non-HP nodes are
on the LAN and the network directory has been
configured. Refer to Chapter 13 , “Network Directory,”
for information about the network directory.
Default value: N
Range: Y or N
Enable Ethernet? (Y/N)
This flag enables the Ethernet protocol to run either by
itself or with the IEEE802.3 protocol. You can enable
one or the other or both of these protocols
simultaneously. One or the other must be enabled (you
cannot disable both). Ethernet is enabled by default.
Disabling Ethernet has the effect of disabling the ARP
protocol as well.
Default value: Y
Range: Y or N
Enable IEEE802.3? (Y/N)
This flag enables the IEEE 802.3 protocol to run either
by itself or with the Ethernet protocol. You can enable
one or the other or both of these protocols
simultaneously. One or the other must be enabled (you
cannot disable both). IEEE 802.3 is enabled by default.
Disabling IEEE 802.3 has the effect of disabling the
probe protocol as well.
Default value: Y
Range: Y or N