NS3000/iX NMMGR Screens Reference Manual - Edition 9 (36922-90040)

Chapter 5 93
LAN Network Interface Configuration Screens
Probe Protocol Configuration
Probe Protocol Configuration
The Probe Protocol Configuration screen (#92) in Figure 5-6 is
displayed when you press the
[Go To PROBE] function at the Protocol
Configuration screen (Figure 5-4). It is also displayed when you type
the path name:
@NETXPORT.NI.NIname.PROTOCOL.PROBE
in the command window of any screen and press the [Enter] key, where
NIname is a configured LAN NI.
Figure 5-6 Probe Protocol Configuration Screen
This screen allows you to configure the information required for the
probe protocol. The probe protocol exists on an IEEE 802.3 LAN
network to provide a means of exchanging addressing and naming
information between nodes. Press the
[Save Data] function key to
transfer the data displayed on the screen to the configuration file you
are creating or updating. Verify that the data record has been created
by checking that the Data flag is set to Y.