Owner's manual
Table Of Contents
- Contents
- Introduction
- Installation
- Library Configuration
- Changing Default Configuration Settings
- Setting a SCSI ID
- Setting Up a Reserved Slot
- Reserved Slot Numbering
- Figure 24 Reserved slot locations, SDLT
- Figure 25 Reserved slot locations, Ultrium (MSL6030)
- Figure 26 Reserved slot locations, lower module, SDLT
- Figure 27 Reserved slot locations, lower module, Ultrium (MSL6060)
- Figure 28 Total reserved slots screen
- Figure 29 Reserved slots numeric keypad screen
- Figure 30 Total reserved slots confirmation screen
- Reserved Slot Numbering
- Configuring the Network Settings
- Operation
- Front Panel
- Library Display Screens and Options
- Menu Selections
- Inserting and Removing Tape Cartridges
- Remote Management Interface
- Maintenance
- Troubleshooting
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Canadian notice (Avis Canadien)
- European Union notice
- Japanese notices
- Korean notices
- Taiwanese notices
- Laser compliance notices
- Recycling notices
- Disposal of waste equipment by users in private household in the European Union
- Danish notice
- Dutch notice
- Czecholslovakian notice
- Estonian notice
- Finnish notice
- French notice
- German notice
- Greek notice
- Hungarian notice
- Italian notice
- Latvian notice
- Lithuanian notice
- Polish notice
- Portuguese notice
- Slovakian notice
- Slovenian notice
- Spanish notice
- Swedish notice
- Specifications
- Electrostatic Discharge
- Configuration Examples
- Optional Fibre Channel Card
- Index
Troubleshooting130
701B Invalid L-drive number to convert
(Attempted to send a command to a
drive, but the logical drive number is out
of range.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
701C Invalid P-drive number to convert
(Attempted to send a command to a
drive, but the physical drive number is out
of range.)
• Press the Enter button clear the
message.
• Cycle power to the library.
• Ensure the drive shows good status
through the drive status window.
701D Invalid mod number to convert
(Attempted to send a command to a drive
in a remote module, but the module
number is out of range.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
701E Unknown drive type
(Attempted to show detailed drive status
of a drive whose type is unknown.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
701F The SCSI response was not expected
(The command response from the SCSI
task in a remote module was
unexpected.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
7020 The Flash response was not expected
(The command response from the Flash
task in a remote module was
unexpected.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
Table 10 Fault Symptom Codes (continued)
FSC Message ERP