Owner manual

Chapter 1 Controls, Ports and Indicators
2
Table 1-1. Control Panel Switches and Indicators
Control/Indicator Description
Power On/Off/Sleep
Switch & LED
Power
Switch
Power
LED
The power switch turns the Netserver power On or Off. If
sleep states are available, it also transitions between Power
On and sleep states.
Sleep states are NOS dependent and only available if your
NOS supports power management based on the ACPI
(Advanced Configuration and Power Interface) standard.
Refer to “Applying Power to the HP Netserver” and
“Sleep States (ACPI)” later in this chapter.
The LED indicates the power state of the Netserver:
• Steady Green indicates the Netserver is operating
normally.
• Blinking Green indicates the Netserver is in a sleep
state and under ACPI control.
• Off (unlit) indicates the Netserver is powered off or
in standby mode.
Reset Switch
RESET
This switch creates a hard system reset, which is
equivalent to a power-on reset.