Manual

Chapter 6 Troubleshooting
49
Message Corrective Action
Operating system
not found
Check whether the drive from which you are booting has
the power and SCSI flat cables connected. Verify that the
SCSI cable is securely plugged into the SCSI controller
board. Narrow (50-pin) SCSI devices require the wide-
to-narrow SCSI adapter with the white body on the SCSI
cable.
Check that the boot device is enabled in the Hardware
Security submenu under the Security menu of the Setup
utility. If possible, check the drive by moving it to
another system. If the problem persists, contact your HP
support organization.
Verify that the boot device has an operating system
installed.
Keyboard error Check that the keyboard is connected to the correct
connector (not the mouse connector) at the rear of the
system.
Replace the keyboard. If the problem persists, contact
your HP support organization.
Mouse error Check that the mouse is connected to the correct
connector (not the keyboard connector) at the rear of
the system.
Replace the mouse. If the problem persists, contact your
HP support organization.
Incorrect System
Configuration
Press the F2 key to run the Setup utility. Change settings
as required. Press the F10 function key to exit, and
answer "Yes" to save the changes.
No Error Messages Displayed
If a POST error is detected before video display starts, a beep error message may
be generated. If so, refer to the list of Beep Codes in Information Assistant.
General Checks
1. All external cables and power cables are firmly plugged in.
2. The power outlet is working.