User Manual

To start a data refresh immediately:
1. Click the Refresh link in the top right corner of any Storage Module for vCenter page.
The HP Insight Software tab displays the options shown in Figure 13 (page 34).
Figure 13 Manual data refresh options
2. Click OK to continue the data refresh, or click Cancel to stop the refresh.
Canceling a data refresh
To cancel a data refresh:
1. Click the Refresh link in the top right corner of any Storage Module for vCenter page.
The HP Insight Software tab displays the options shown in Figure 14 (page 34).
Figure 14 Cancel data refresh options
2. Click Stop.
Restarting a data refresh
Restarting a data refresh stops the existing refresh process and starts a new one. If a data refresh
is in progress, and changes are made that will require another refresh, use the following procedure
to start a new refresh immediately instead of waiting for the current refresh to finish:
1. Click the Refresh link in the top right corner of any Storage Module for vCenter page.
The HP Insight Software tab displays the options shown in Figure 14 (page 34).
2. Click Restart.
Changing the automatic data refresh settings
You can change the default data refresh settings by editing the configuration.xml file.
1. Open the configuration.xml file, which is located in the following directory (assuming
that the default installation directory was used):
• x64 systems: C:\Program Files (x86)\HP\HP Insight Control Storage
Module for vCenter\Storage Integration\config
• 32-bit systems: C:\Program Files\HP\HP Insight Control Storage Module
for vCenter\Storage Integration\config
34 Using Insight Control for vCenter