Safety data sheet

Skin contact Wash affected areas thoroughly with mild soap and water. Get medical attention if irritation
develops or persists.
Eye contact Do not rub eyes. Immediately flush with large amounts of clean, warm water (low pressure) for at
least 15 minutes or until particles are removed. If irritation persists, consult a physician.
Ingestion Rinse mouth with water. Drink one to two glasses of water. If symptoms occur, consult a
physician.
5. FIRE-FIGHTING MEASURES
Flash point Not applicable
Fire fighting
equipment/instructions
If fire occurs in the printer, treat as an electrical fire.
Suitable extinguishing media CO2, water, or dry chemical
Extinguishing media which
must not be used for safety
reasons
None known.
Unusual fire & explosion
hazards
Like most organic material in powder form, toner can form explosive dust-air mixtures when finely
dispersed in air.
Specific methods None established.
Hazardous combustion
products
Carbon monoxide and carbon dioxide.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions Minimise dust generation and accumulation.
Environmental precautions Do not flush into surface water or sanitary sewer system. See also section 13 Disposal
considerations.
Other information Slowly vacuum or sweep the material into a bag or other sealed container. If a vacuum is used,
the motor must be rated as dust explosion-proof. Clean remainder with a damp cloth or vacuum
cleaner. Fine powder can form explosive dust-air mixtures. Dispose of in compliance with federal,
state, and local regulations.
7. HANDLING AND STORAGE
Handling Keep out of the reach of children. Avoid inhalation of dust and contact with skin and eyes. Use
with adequate ventilation. Keep away from excessive heat, sparks, and open flames.
Storage Keep out of the reach of children. Keep tightly closed and dry. Store away from strong oxidizers.
Store at room temperature.
Germany
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure limit values
Components Type
Value
Form
Amorphous silica (7631-86-9) 4.0000 mg/m3 Inhalable fraction.AGW
Additional exposure data USA OSHA (TWA/PEL): 15 mg/m3 (Total Dust), 5 mg/m3 (Respirable Fraction)
ACGIH (TWA/TLV): 10 mg/m3 (Inhalable Particulate), 3 mg/m3 (Respirable Particulate)
Amorphous silica: USA OSHA (TWA/PEL): 20 mppcf 80 (mg/m3)/%SiO2, ACGIH (TWA/TLV): 10
mg/m3
TRGS 900 (Luftgrenzwert) - 10 mg/m3 (Einatembare partikel), 3 mg/m3 (Alveolengängige fraktion)
UK WEL: 10 mg/m3 (Respirable Dust), 5 mg/m3 (Inhalable Dust)
Exposure controls Use in a well ventilated area.
Occupational exposure controls
General No personal respiratory protective equipment required under normal conditions of use.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance Fine powder
Physical state Solid
Form solid
Color Black.
Odor Slight plastic odor
Material name: Q2612A-L-AD
Q2612A-L-AD Version #: 09 Revision date: 16-Jul-2010 Print Date: 16-Jul-2010
SDS GERMANY
2 / 5