Security Solutions

# cmmakepkg –m dts/cccaeva –m sg/filesystem -m sg/package_ip -m
tkit/apache/apache temp.config
2. Edit the following attributes in the temp.config file:
• dts/caeva/dts_pkg_dir
This is the package directory for the modular package. This value must be unique for all
the packages.
• AUTO_RUN
Set the value of this parameter to no.
• DT_APPLICATION_STARTUP_POLICY
This parameter defines the preferred policy by allowing the application to start with
respect to the state of the data in the local volumes. This can be either
Availability_Preferred or Data_Currency_Preferred.
• DR_GROUP_NAME
The name of the DR group used by this package. The DR group name is defined when
the DR group is created.
• DC1_STORAGE_WORLD_WIDE_NAME
The world wide name of the EVA storage system that resides in Data Center 1. This
storage system name is defined when the storage is initialized.
• DC1_SMIS_LIST
A list of the Windows management servers, which is located in Data Center 1.
• DC1_HOST_LIST
A set of the cluster nodes, which is located in Data Center 1.
• DC2_STORAGE_WORLD_WIDE_NAME
The world wide name of the EVA storage system that is located in Data Center 2. This
storage system name is defined when the storage is initialized.
• DC2_SMIS_LIST
A list of the Windows management servers, which is located in Data Center 2.
• DC2_HOST_LIST
A list of the clustered nodes, which is located in Data Center 2.
There are additional parameters available in the package configuration file. HP recommends
that you retain the default values of these variables are retained unless there is a specific
business requirement to change them.
For more information on the additional parameters, see the section “Package Attributes for
Continentalcluster with Continuous Access EVA” (page 95).
3. Validate the package configuration file.
# cmcheckconf -P temp.config
4. Apply the package configuration file.
# cmapplyconf -P temp.config
18 Building the Continentalclusters configuration