Security Solutions

7. Halt the monitor package ccmonpkg and apply the edited configuration file.
For Example:
# cmhaltpkg ccmonpkg
# cmapplyconf –P cc_new.config
8. Start the monitor package ccmonpkg after applying the configuration.
For Example:
# cmrunpkg ccmonpkg
Configuring Continentalclusters rehearsal packages
The rehearsal packages use all the modules that are used to create the recovery package. However,
when using any of the pre-integrated physical replication solutions, the replication technology
specific Continentalclusters module must not be included.
If Continentalclusters is used with EMC SRDF, then set the variable AUTOSPLITR1 to 1 before
splitting the replication links. This ensures high availability of primary packages within the primary
site in case of failures during the rehearsal process.
For Example:
In a Continentalclusters configuration that uses Continuous Access P9000 and XP, the recovery
package must be created with dts/ccxpca module. While creating the rehearsal package for this
recovery group, the dts/ccxpca module must not be included.
To create a rehearsal package:
1. Create a package configuration identical to the recovery package configuration but without
any Continentalclusters module.
2. Change the values of the following parameters:
• package_name
• package_ip
• service_name
For all other parameters, provide the same values as specified in the recovery package
configuration.
3. Validate the package configuration.
# cmcheckconf –P <package_name>
4. Apply the package configuration.
# cmapplyconf –P <package_name>
Modifying Continentalclusters configuration
The Continentalclusters parameter CONTINENTAL_CLUSTER_STATE_DIR is the absolute path to
the filesystem directory created in section “Setting up the file system for Continentalclusters state
directory” (page 36).
To update the configuration with the rehearsal packages and the Continentalclusters shared directory
name:
1. In the Cluster section of the Continentalclusters configuration ASCII file, uncomment the
CONTINENTAL_CLUSTER_STATE_DIR field, and against it enter the value for filesystem
directory that was added in the fs_name of ccmonpkg configuration.
For Example:
38 Disaster recovery rehearsal in Continentalclusters