Security Solutions

E Package attributes
Package Attributes for Continentalcluster with Continuous Access for P9000
and XP
This appendix lists all Package Attributes for Metrocluster with Continuous Access for P9000 and
XP. HP recommends that you use the default settings for most of these variables, so exercise caution
when modifying them:
AUTO_FENCEDATA_SPLIT (Default = 1)
This parameter applies only when the fence level is set to
DATA, which will cause the application to fail if the
Continuous Access link fails or if the remote site fails.
Values:
0 – Do NOT startup the package at the primary site. Require
user intervention to either fix the hardware problem or to
force the package to start on this node by creating the
FORCEFLAG file. Use this value to ensure that the SVOL
data is always current with the trade-off of long application
downtime while the Continuous Access link and/or the
remote site are being repaired.
1 – (DEFAULT) Startup the package at the primary site.
Request the local disk array to automatically split itself from
the remote array. This will ensure that the application able
to startup at the primary site without having to fix the
hardware problems immediately. Note that the new data
written on the PVOL will not be remotely protected and the
data on SVOL non-current. When the Continuous Access
link and/or the remote site is repaired, you must manually
use the command “pairresync” to re-join the PVOL and
SVOL. Until that command successfully completes, the PVOL
will NOT be remotely protected and the SVOL data will not
be current. Use this value to minimize the down time of the
application with the trade-off of having to manually
resynchronize the pairs while the application is running at
the primary site.
If the package has been configured for a three data center
environment, this parameter is applicable only when the
package is attempting to start up in either the primary (DC1)
or secondary (DC2) data center. This parameter is not
relevant in the recovery cluster or the third data center. Use
this parameter’s default value in the third data center.
AUTO_NONCURDATA (Default = 0)
This parameter applies when the package is starting up with
possible non-current data under certain Continuous Access
pair states. During failover, this parameter will apply when
the SVOL is in the PAIR or PFUL state and the PVOL side is
in the PSUE, EX_ENORMT, EX_CMDIOE or PAIR (for
Continuous Access Journal) state. During failback, this
parameter will apply when the PVOL is in the PSUS state
and the SVOL is in the EX_ENORMT or EX_CMDIOE state.
When starting the package in any of the above states, you
run the risk of losing data.
Values:
88 Package attributes