White Paper

19
Starting a Serviceguard NFS failover package
1. Copy the configuration files to each server in the cluster:
# rcp –p /etc/cmcluster/nfs/* {hostname}:/etc/cmcluster/nfs
2. Verify the cluster and package configuration files on each server:
# cmcheckconf –k –v –C /etc/cmcluster/cluster.conf –P
/etc/cmcluster/nfs/nfs1.conf –P /etc/cmcluster/nfs/nfs2.conf
3. Verify and apply the cluster package configuration files on a single server:
# cmapplyconf –v –C /etc/cmcluster/cluster.conf –P
/etc/cmcluster/nfs/nfs1.conf –P /etc/cmcluster/nfs/nfs2.conf
4. Run the failover packages:
# cmrunpkg –n thyme –v SG-NFS1
# cmrunpkg –n basil –v SG-NFS2
If you run the cmviewcl command, the output is similar to the following:
# cmviewcl
CLUSTER STATUS
cluster1 up
NODE STATUS STATE
thyme up running
PACKAGE STATUS STATE AUTO_RUN NODE
SG-NFS1 up running enabled thyme
NODE STATUS STATE
basil up running
PACKAGE STATUS STATE AUTO_RUN NODE
SG-NFS2 up running enabled basil
MULTI_NODE_PACKAGES
PACKAGE STATUS STATE AUTO_RUN SYSTEM
SG-CFS-pkg up running enabled yes
SG-CFS-DG-1 up running enabled no
SG-CFS-MP-1 up running enabled no
SG-CFS-MP-2 up running enabled no
7. Configuring Serviceguard NFS Modular Package over
CFS Packages
This section describes how to configure and start Serviceguard NFS modular packages
in a Serviceguard over CFS environment. It is assumed that you have already setup
your Serviceguard cluster, and have performed the steps listed in the “Before Creating