White Paper

feature functions properly in A.11.18, install the following patch on all servers that will

be configured as nodes in the cluster.

PHSS_39484 1.0 Serviceguard A.11.18.00

6. Configuring Serviceguard NFS Legacy Package over CFS

Packages

This section describes how to configure and start Serviceguard NFS legacy packages in

a Serviceguard over CFS environment. It is assumed that you have already setup your

Serviceguard cluster, and have performed the steps listed in the “Before Creating a

Serviceguard NFS Legacy Package” section of the Serviceguard NFS Toolkit A.11.11.06,

A.11.23.05 and A.11.31.08 Administrator’s Guide to configure the

/etc/rc.config.d/nfsconf file, start the NFS server, configure the disk hardware, and

setup volume groups, logical volumes, and file systems. It is assumed that you have

setup CFS as documented in the Veritas Storage Foundation Cluster File System

Installation and Administration Guide, and that you have already started the

Serviceguard CFS multi-node packages.

In the following example, the CFS file systems are /cfs1 and /cfs2, and they

correspond to Serviceguard CFS multi-node packages SG-CFS-MP-1 and SG-CFS-MP-2.

The cluster ASCII configuration file is assumed to be /etc/cmcluster/cluster.conf. The

cluster name is cluster1 and there are two nodes, thyme and basil. If you run the

cmviewcl command after setting up the Serviceguard CFS packages, the output is

similar to the following:

# cmviewcl

CLUSTER STATUS

cluster1 up

NODE STATUS STATE

thyme up running

NODE STATUS STATE

basil up running

MULTI_NODE_PACKAGES

PACKAGE STATUS STATE AUTO_RUN SYSTEM

SG-CFS-pkg up running enabled yes

SG-CFS-DG-1 up running enabled no

SG-CFS-MP-1 up running enabled no

SG-CFS-MP-2 up running enabled no

Create a directory on each server in the cluster to hold all the configuration files (if this

directory already exists you should save the contents before continuing):

# mkdir /etc/cmcluster/nfs

The rest of the configuration is dependent upon whether or not the cluster requires file

locking (as described in the Issues and Limitations with the current CFS

implementation section). If file locking is not required, follow the instructions in section

“Serviceguard NFS Legacy Package over CFS Packages without File Locking”. If file