Manual

Syntax
Authenticating with credentials for the first time:
hpsum login [--username rono --password pwd123 --port 63001 --ssl_port
63002]
Authenticating with current credentials:
hpsum login
Parameters
DescriptionOption
The HP SUM script initiates this action.hpsum
The command to set credentials for the HP SUM session.login
Optional parametersusername, password
Return codes
TextLinuxWindowsReturn code
The command was successful.00SUCCESS_NO_REBOOT
A general failure occurred. For details, see the logs.255-1FAILURE_GENERAL
A bad input parameter was encountered. For details, see
the logs.
254-2FAILURE_BAD_PARM
The command failed. For details, see the logs.252-4FAILURE_COMMAND_FAILED
Example
Windows sample command line
C:\> hpsum login /username rono /password pwd123 /ssl_port 9091
Linux/HP-UX sample command line
$ hpsum login --username rono --password pwd123 --ssl_port 9091
SetAttributtes
Enables you to change attributes for an HP SUM session, node, or baseline. For a full list of attributes
you can change, run the getattributes command.
setattributtes enables you to change the attributes of an HP SUM session, node, or baseline.
This command might return an invalid parameter notice if the permissions are not correct, or if
either the parameter is not part of the requested set or if the value is not allowed.
You can set the following installation attributes: force, rewrite, downgrade, action, delay,
and message (reboot message).
Syntax
hpsum setattributes [--nodes [N1 attribute=value] [N2 attribute=value]
120 Console Commands