Manual

DescriptionInstallation options
components are optional. This argument does not apply
to HP Integrity servers.
Specifies which AMS components can be installed along
with SNMP components. The AMS and SNMP components
/use_ams
are available to select by default. When the /use_ams
argument is used, the SNMP components are required,
and the WMI components are optional.
This filter switch allows you to see only the firmware
components needed for installation. When you are using
/romonly
this filter switch, you must exit and restart HP SUM if you
want to return to an unfiltered state.
Do not use the /romonly argument with the
/softwareonly argument. (Applies to firmware only.)
This filter switch allows you to see only the software
components needed for installation. When you are using
/softwareonly
this filter switch, you must exit and restart HP SUM if you
want to return to an unfiltered state.
Do not use the /softwareonly argument with the
/romonly argument.
HP SUM 6.x does not support /express command. If you
scripts contain this command, HP SUM will execute this
command the same way it runs /silent.
/express
DescriptionOverriding errors
Specifies that if a TPM is enabled, the warning message
should be ignored and component installation can continue.
/tpmbypass or /ignore_tpm
For more information about TPM, see “Disabling BitLocker
to permit firmware updates (Windows only)” (page 16).
Allows the installation to proceed on a Superdome 2 node
even when warnings are returned during analysis.
/ignore_warnings
Causes the installation to continue and ignore errors. Valid
values are as follows:
/continue_on_error <error>
* <error>=ServerNotFound and
* <error>=BadPassword.
* <error>=FailedDependencies
You can use the ServerNotFound option to bypass
inactive or unavailable remote hosts when you are
deploying firmware or software to multiple remote hosts at
the same time.
Defines the behavior when a remote node has an existing
HP SUM session in progress. It overrides the session in
/override_existing_connection
progress and re-initializes the installation framework on
the remote host.
Provides HP SUM <parameter> the information on how to
proceed when a component has a failed dependency. The
/On_failed_dependency: <parameter>
supported parameters for this argument are OmitHost
(default), OmitComponent , and Force. OmitHost
causes the host to be put into a failure state, and no
installation is attempted. OmitComponent deselects the
affected components and proceeds with any updates that
do not have dependency failures. Force attempts all
updates, even if they have dependency failures.
Command-line interface 73