Manual

DescriptionParameter
Causes the installation to continue and ignore errors.IGNOREERRORS
The ServerNotFound option can be used to bypass inactive or
unavailable remote hosts when deploying firmware or software to multiple
remote hosts at the same time.
Use FailedDependencies to ignore any failed dependencies and
proceed with the ones that are ready to be installed.
Possible values:
ServerNotFound, BadPassword, FailedDependencies
Provide a single local baseline path. This action creates an inventory from
the given path instead of the local or default baseline.
SOURCEPATH
Possible values:
Directory path
This is a filter switch for use with bundles. The parameter enables you to
use the latest version of the bundle when multiple versions of bundles are
listed on the command line.
USELATEST
If no bundles are specified on the command line, and multiple bundles are
in the directory, this parameter enables HP SUM to use the bundle that
has the latest version for installation.
Possible values:
YES, NO
Simulates the installation for a test run. Nothing is installed.DRYRUN
Possible values:
YES, NO
Specify the HP SUM CLI options inside the input file, which overrides the
configuration settings. Parameters can be separated by a semi-colon,
comma, or a space.
OPTIONS
This parameter replaces the LSPOPTIONS parameter that was previously
supported with LDU.
Possible values:
One or more CLI switch
Specifies that components that use AMS and WBEM Providers listed as
optional updates on the Components Selection screen.
NOMGMT
In silent mode, HP SUM does not update AMS or WBEM Providers.
NOTE: You can only configure SNMP in HP SUM GUI mode.
Possible values:
YES, NO
Specifies that components that use WMI protocol are available to be
selected for installation.
USEWMI
These components are optional by default and are not installed unless this
parameter is used. When the /usewmi parameter is used. This parameter
does not apply to HP Integrity servers.
Possible values:
YES, NO
Specifies that AMS agentless management service components are
available to be selected for installation.
USEAMS
This option will only apply to Gen8 and later servers. If this parameter is
set for a ProLiant G7 and earlier server model, it will be ignored.
Input files 85