(User Guide) Instruction Manual

The following table shows what updates occur if WBEM switches are currently installed.
Gen8 serversG7 and earlier serversCommand
WBEMWBEMno switches
WBEM and AMSWBEM/use_ams
WBEM and SNMPWBEM and SNMP/use_snmp
WBEMWBEM/use_wmi
AMS, SNMP, and WBEMWBEM and SNMP/use_ams /use_snmp
WBEM and AMSWBEM/use_ams /use_wmi
WBEM and SNMPWBEM and SNMP/use_wmi /use_snmp
AMS, SNMP, and WBEMWBEM and SNMP/use_ams /use_wmi /use_snmp
The following table shows what updates occur if AMS switches are currently installed.
Gen8 serversG7 and earlier serversCommand
AMSN/Ano switches
AMSN/A/use_ams
AMS and SNMPN/A/use_snmp
AMS and WBEMN/A/use_wmi
AMS and SNMPN/A/use_ams /use_snmp
AMS and WBEMN/A/use_ams /use_wmi
AMS, SNMP, and WBEMN/A/use_wmi /use_snmp
AMS, SNMP, and WBEMN/A/use_ams /use_wmi /use_snmp
NOTE: G7 and earlier servers do not support AMS.
Command-line arguments
HP SUM recognizes the following command-line arguments, which you can use to pre-populate
the GUI on the Source Selection and Review/Install Updates screens. If you specify the target and
credentials, use the /s[ilent] parameter to proceed with the installation.
You cannot use some arguments, such as /romonly and /softwareonly, together.
DescriptionHelp
Displays command line help information./h[elp] or /?
DescriptionInstallation options
Overrides or downgrades an existing component
installation. This produces the same results as
/f:software.
/f[orce]
Overrides or downgrades the existing installation of
components in the selected bundle.
/f[orce]:bundle
Overrides or downgrades the existing installation of the
selected firmware components (applies to firmware only).
/f[orce]:rom
36 Using scripts to deploy updates