(User Guide) Instruction Manual

DescriptionInstallation options
Specifies that components that use SNMP protocol and the
AMS components are available for installation by default.
/use_snmp
When the /use_snmp argument is used, the AMS
components are required, but the WMI components are
optional.
Specifies that components that use the WMI protocol are
available for installation. These components are optional
/use_wmi
and are not installed unless this argument is used. When
the /use_wmi argument is used, and the /use_snmp &
/use_ams arguments are not, the SNMP and AMS
components are optional. This argument does not apply
to HP Integrity servers.
Specifies which AMS components can be installed along
with SNMP components. The AMS and SNMP components
/use_ams
are available to select by default. When the /use_ams
argument is used, the SNMP components are required,
and the WMI components are optional.
This filter switch allows you to see only the firmware
components needed for installation. When you are using
/romonly
this filter switch, you must exit and restart HP SUM if you
want to return to an unfiltered state.
Do not use the /romonly argument with the
/softwareonly argument. (Applies to firmware only.)
This filter switch allows you to see only the software
components needed for installation. When you are using
/softwareonly
this filter switch, you must exit and restart HP SUM if you
want to return to an unfiltered state.
Do not use the /softwareonly argument with the
/romonly argument.
Starts an express installation for the local host only. HP
SUM performs discovery, installation, and exits without
user interaction. You can cancel or terminate HP SUM.
/express_install
DescriptionOverriding errors
Specifies that if a TPM is enabled, the warning message
should be ignored and component installation can continue.
/tpmbypass or /ignore_tpm
For more information about TPM, see “Disabling BitLocker
to permit firmware updates” (page 13).
Allows the installation to proceed on a Superdome 2 target
even when warnings are returned during analysis.
/ignore_warnings
Causes the installation to continue and ignore errors. Valid
values are as follows:
/continue_on_error <error>
* <error>=ServerNotFound and
* <error>=BadPassword.
* <error>=FailedDependencies
You can use the ServerNotFound option to bypass
inactive or unavailable remote hosts when you are
deploying firmware or software to multiple remote hosts at
the same time.
Defines the behavior when a remote target has an existing
HP SUM session in progress. It overrides the session in
/override_existing_connection
progress and re-initializes the installation framework on
the remote host.
Command-line interface 39