(User Guide) User guide

Scripted deployment 34
Installation options Description
used, the AMS components are required, but the WMI components are optional.
/use_wmi
This argument specifies that components that use WMI protocol are available for
installation. These components are optional and are not installed unless this argument
is used. When the /use_wmi argument is used, and the /use_snmp & /use_ams
arguments are not, the SNMP and AMS components are optional. This argument does
not apply to HP Integrity Servers.
/use_ams
This argument specifies that components which Agentless Monitoring service (AMS)
components can be installed along with SNMP components. The AMS and SNMP
components are available to select by default. When the /use_ams argument is used,
the SNMP components are required, and the WMI components are optional.
/romonly
This argument is a filter switch and allows the user to only see the firmware components
needed for installation. When using this filter switch, you must exit and restart HP Smart
Update Manager if you wish to return to an unfiltered state.
Do not use the /romonly argument with the /softwareonly argument.(Applies to
firmware only.)
/softwareonly
This argument is a filter switch and allows the user to only see the software componen
ts
needed for installation. When using this filter switch, you must exit and restart HP Smart
Update Manager if you wish to return to an unfiltered state.
Do not use the
/softwareonly
argument with the
/romonly
argument.
/express_install
This argument sta
rts express install (for local host only). The HP Smart Update Manager
(HPSUM) performs discovery,install, or exit without user interaction. The user can
cancel or terminate HP Smart Update Manager.
Overriding errors Description
/tpmbypass or
/ignore_tpm
These arguments specifies that if a Trusted Platform Module (TPM) is enabled, the
warning message should be ignored and component installation will be allowed to
continue.
/ignore_warnings
This argument allows the installation to proceed on a
Superdome 2 target even when
warnings are returned during analysis.
/continue_on_erro
r <error>
This argument causes the installation to continue and ignore errors. Valid values are :
* <error>=ServerNotFound and
* <error>=BadPassword.
* <error>=FailedDependencies
The ServerNotFound option can be used to bypass inactive or unavailable remote hosts
when deploying firmware or software to multiple remote hosts at the same time.
/override_existin
g_connection
This argument is used to define the behav
ior when a remote target has an existing HP
Smart Update Manager session in progress. It overrides the session in progress and
reinitializes the installation framework on the remote host.
/On_failed_depend
ency: <parameter>
This argument provides HP Smart Update Manager <parameter> the information of
how to proceed when a component has a failed dependency. The supported
parameters for this argument are Omit_Host (default), Omit_Component and Force.
Omit_Host causes the host to be put into a failure state and no installation is attempted.
Omit_Component deselects the affected component(s) and proceeds with any updates
that do not have dependency failures. Force attempts all updates, even if they have
dependency failures.
Reboot options Description
/r[eboot]
If the following conditions are met, this argument causes the server (or host server in a
remote installation) to reboot:
•
The
/reboot
option is selected or given as a command-line argument.