Installation Manual

HP Storage Essentials SRM 6.0 Installation Guide 135
Discovering 3PAR Storage Systems
To discover a 3PAR storage system, the SMI-S server for the 3PAR storage system must be running.
By default, the 3PAR SMI-S server is not started on the array. To start the SMI-S server, start the
InForm CLI and run the following command:
startcim
This command starts the SMI-S server within a minute or so.
NOTE: You do not need to provide the interop namespace because the management server
includes the interop namespace for 3PAR storage systems in its default list.
To discover 3PAR storage systems, enter the following information in HP SIM
• The IP address or system name for the storage system.
• User name of the storage system.
• Password of the storage system.
HP EVA storage
systems
Discover the server running
Command View EVA.
See Discovering HP
StorageWorks EVA Arrays,
page 143.
HP XP storage
systems
Discover the server running the
SMI-S provider or the built-in
provider.
See Discovering HP
StorageWorks XP Arrays,
page 145.
IBM storage systems
and System Storage
SAN Volume
Controller
Discover the IBM CIMOM or SVC. See Discovering IBM Storage
Systems or IBM SVCs, page 146.
Sun StorEdge 3510 Discovered through proxy software
called Sun StorEdge™
Configuration Service.
See Discovering Sun StorEdge
Storage Systems, page 148.
Sun StorEdge 6920
and 6940
Discover the storage system
directly.
See Discovering Sun StorEdge
6920 and 6940 Storage Systems,
page 149.
Sun StorEdge 6130 Discover the storage system
directly.
See Discovering Sun StorEdge
6130 Storage Systems,
page 149.
Xiotech storage
systems
Discover the storage system
directly.
See Discovering Xiotech Storage
Systems, page 149.
Table 6 Discovery Requirements for Storage Systems (continued)
Element Discovery Requirements For Additional Information