Installation Manual

Discovering Switches, Storage Systems, NAS Devices, and Tape Libraries148
7. Verifying that the CIM Agent is able to communicate with the storage devices. Enter the
following command to verify communication:
verifyconfig -u username -p password where username and password are the
credentials to access CIM Agent and were created by setuser.
Discovery Information for IBM Storage Systems/SVCs
To discover an IBM storage system or an IBM System Storage SAN Volume Controller (SVC), enter
the following information in HP SIM:
• IP address or system name for the system running the IBM CIMOM or SVC you want to
discover.
• Port number for the IBM CIMOM or SVC if a non-default port is used.
• User name of the IBM CIMOM or SVC.
• Password of the IBM CIMOM or SVC.
NOTE: The IBM CIMOM user name and password are defined with the setuser
command.
Discovering Sun StorEdge Storage Systems
You can discover the following Sun StorEdge systems. For more details, see the support matrix.
• Discovering Sun StorEdge 3510 Storage Systems, page 148
• Discovering Sun StorEdge 6920 and 6940 Storage Systems, page 149
• Discovering Sun StorEdge 6130 Storage Systems, page 149
Discovering Sun StorEdge 3510 Storage Systems
Before you can discover a Sun StorEdge 3510 storage system, you must set up a Sun StorEdge
3510 SMI-S provider and a Sun StorEdge Configuration Service. The provider cannot be installed
on the same computer as the management server due to a port conflict.
The Sun StorEdge Configuration Service can be installed in one of the following locations:
• On the same computer as the Sun StorEdge 3510 SMI-S provider
• On the management server
• On a separate computer
To install the Sun StorEdge Configuration Service you must install the following packages:
• Sun StorEdge Configuration Service Console (SUNWscsu)
• Sun StorEdge Configuration Service Agent (SUNWscsd)
• Sun StorEdge Diagnostic Reporter Agent (SUNWscsa)
You must also install the following packages. Contact Sun technical support for information on how
to obtain and configure these packages.
• WBEM Solutions J WBEM Server 1.0