Installation Manual
Troubleshooting404
• No Stitching for Brocade Switches with Firmware 3.2.0, page 407
• Link Between a Brocade Switch and a Host Disappears from the Topology, page 407
• Incorrect Topology Sometimes Displayed for CNT Switches, page 408
• Device Locking Mechanism for Brocade Element Manager Query/Reconfiguration, page 408
• A Discovered Sun StorEdge A5000 JBOD Does Not Display Its WWN Properly, page 408
• ”Sun 6920 Storage Systems: “ReplicatorSQLException: Database create error” During
Discovery Data Collection” on page 408
• ”Mirrored Volumes Cannot Be Provisioned on Sun 6920 Storage Systems” on page 408
• Unable to Monitor McDATA Switches, page 408
• Unable to Detect a Host Bus Adapter, page 409
• Navigation Tab Displays Removed Drives as Disk Drives, page 409
• Unable to Obtain Information from a CLARiiON Storage System, page 409
• Discovery Fails Too Slowly for a Nonexistent IP Address, page 409
• “CIM_ERR_FAILED” Message, page 410
• Communicating with HiCommand Device Manager Over SSL, page 412
• Unable to Discover a UNIX Host Because of DNS or Routing Issues, page 413
About the Topology
The software determines the topology by looking at the following:
• Fibre Channel switch - The Fibre Channel switch contains a list of all elements within the fabric.
The software obtains a detailed listing of all elements connected to the switch fabric.
• A host containing a Host Bus Adapter (HBA) - All Fibre Channel host adapters look for available
elements attached to the HBA. This information is gathered by CIM extensions and sent to the
management server.
Table 30 on page 405 provides details about how to correct problems that might occur during
discovery and data collection.