Installation Manual

HP Storage Essentials SRM 6.0 Installation Guide 195
2. If you see the message “Disk history since boot not available,” enter the following at the
command prompt to enable the retention of disk activity history:
# chdev -l sys0 -a iostat=true
Starting the CIM Extension Manually
The management server can only obtain information from this host when the CIM extension is
running. To start the CIM extension, enter the following in the /opt/APPQcime/tools directory:
# ./start
Keep in mind the following:
• You must have root privileges to run the CIM extension. The CIM extension only provides the
information within the privileges of the user account that started the CIM extension. Only root
has enough privileges to provide the information the management server needs. If you do not
start the CIM extension with root privileges, the management server will display messages
resembling the following: Data is late or an error occurred.
• To configure UNIX CIM extensions to run behind a firewall, see ”Configuring UNIX CIM
Extensions to Run Behind Firewalls” on page 389.
• If you see the message “Fork Function Failed” when you start the CIM extension, the AIX host is
running low on physical or virtual memory. See ”“Fork Function Failed” Message on AIX Hosts”
on page 416.
When you enter the start command, the following message is displayed:
Starting CIM Extension for AIX...
How to Determine if the CIM Extension Is Running
You can determine if the CIM extension is running by entering the following command at the
command prompt:
# ./status
The CIM extension is running when the following message is displayed:
CIM Extension Running: Process ID: 93
where 93 is the process ID running the CIM extension
Configuring CIM Extensions
Configuration information is stored in a configuration text file that is read by the CIM extension on
start-up. The file is named cim.extension.parameters and is located in the
[Installation_Directory]/conf directory on the host. This directory also contains a file
named cim.extension.parameters-sample. This file contains samples of available
parameters and can be copied into the cim.extension.parameters file and used as a
template.
Changing the Port Number
The CIM extension uses port 4673 by default. If this port is already in use, follow these steps to
change the port the CIM extension will access: