Installation Manual

Installing the CIM Extension for NonStop238
• Ensure that adequate swap space is available.
Network Port
By default, the CIM extension uses port 4673 to communicate with the management server.
To ensure that your network port is working properly:
• Verify that the network port is open. Refer to the documentation accompanying your NonStop
host for more information.
• If you need to use a different port, see ”Permanently Changing the Port a CIM Extension Uses
(UNIX Only)” on page 388.
Installing the CIM Extension
Use the following procedure to install the CIM extension for NonStop:
1. Navigate to the default directory.
2. Transfer the depots and install scripts to the host using FTP. NonStop hosts do not support CD
drives.
3. Place the CIM extension CD-ROM into the CD-ROM drive on any local host. Select one of the
following options:
• UNIX/Linux host: Enter the following command at the command prompt to go to the
NonStop directory:
# cd /cdrom/nsk/NSR
• Windows: Browse to your compact disk drive. Enter the following command:
C:\>D:
where D: is the drive where your compact disc resides.
You can also get this information using Windows Explorer.
4. Navigate to the NSR folder of the CIM extension CD-ROM by e n t e ring the fo l l o w ing comman d :
D:\>cd/nsk/NSR
5. Enter the following command to FTP the NonStop depots and install scripts to the NonStop host:
ftp <NonStop host name>
6. Enter the superuser’s username and password when you are prompted. For example:
User (XXX.YYY.hp.com:(none)): super.super
331 Password required for SUPER.SUPER.
Password: XXXXXXXX
230 User SUPER.SUPER logged in.
7. Enter the OSS subsystem at the command prompt:
ftp> quote oss
257 OSS API enabled.
8. Enter the binary mode of the file transfer by entering the following at the command prompt:
ftp > bin
200 Type set to I.