Installation Manual

ManualsBrandsHP ManualsSoftwareHP Storage Essentials Standard Edition SRM Software

291

292

293

294

295

296

297

298

299

300

HP Storage Essentials SRM 6.0 Installation Guide 273

• The Emulex driver does not contain the required library that is required by HP Storage

Essentials. You must install Emulex HBAnywhere software so that HP Storage Essentials can

discover hosts configured with HBAnywhere and hbatest can detect the Emulex host bus

adapter.

To run hbatest:

1. Go to the Solaris/tools directory on the CIM Extension 1 CD-ROM.

2. Enter the following at the command prompt:

./hbatest

The program runs its diagnostics.

Depending on the driver and version of the operating system, the SNIA API library may be installed

with the driver or its utility program provided by the vendor. You can find the API library by

entering the following at the command prompt:

# more /etc/hba.conf

The following are examples of the library names and its path:

Emulex

com.emulex.emulexapilibrary /usr/lib/libemulexhbaapi.so

com.emulex.emulexapilibrary /usr/lib/sparcv9/libemulexhbaapi.so

QLogic

qla2x00 /usr/lib/libqlsdm.so

JNI

JniHbaLib /opt/JNIsnia/Solaris/Jni/32bit/JniHbaLib.so

JniHbaLib /opt/JNIsnia/Solaris/Jni/64bit/JniHbaLib.so

SUN Branded

com.sun.fchba /usr/lib/libsun_fc.so.1

com.sun.fchba64 /usr/lib/sparcv9/libsun_fc.so.1

Installing the CIM Extension

Keep in mind the following:

• Solaris does not support the upgrading of the CIM extension. Before loading a new CIM

extension, see ”Removing the CIM Extension from Solaris” on page 279 to verify no agent

exists.

• The instructions in this section apply if you are doing a local installation of the CIM extension,

as opposed to a scripted or push installation. If you want to perform a scripted or push

installation of the CIM extension, first install the CIM extension locally by following the

instructions in this section, and then performing the scripted or push installation. The instructions

in this section only need to be performed once if you are doing a scripted or push installation.

Contact customer support for information about performing a scripted or push installation.

• The server must be running sh, ksh, or bash shell. C shell is not supported.