Installation Manual

HP Storage Essentials SRM 6.0 Installation Guide 311
The port can be found in the following code:
LISTENER =
(DESCRIPTION_LIST =
(DESCRIPTION =
(ADDRESS_LIST =
(ADDRESS = (PROTOCOL = TCP)(HOST = localhost)(PORT = 1521))
(ADDRESS = (PROTOCOL = IPC)(KEY = EXTPROC0))
)
)
)
f. Select ORACLE from the Database Type menu.
g. Click OK.
6. If the conditions described in the “Discovery of Oracle RAC Instances Using One Instance”
section are satisfied, then all the other instances in the Oracle RAC will also be discovered, and
the Oracle RAC application cluster will also be constructed by the management server.
7. If the other instances of the Oracle RAC are not discovered in the previous step, repeat steps 4
and 5 for each node in the cluster.
About Discovery of an Oracle RAC Application Cluster on a Host Cluster Discovered Using Cluster
Manager
When the underlying host cluster is not discovered, the management server will be “Oracle RAC
safe,” but not fully “Oracle RAC aware.” Each instance will show up as a standalone Oracle
application, and data will be collected for each instance separately (even though both instances
will return identical capacity data). However, the management server does not explicitly identify
and construct the Oracle RAC application cluster. Also, when the underlying host cluster is not
discovered, other instances of the Oracle RAC cannot be discovered automatically as described in
the Discovery of Oracle RAC Instances Using One Instance section.
However, if you create the host cluster at a later point in time, subsequent discovery of any instance
in Oracle RAC will identify and construct the Oracle RAC application cluster. The management
server will shift to “Oracle RAC aware” mode on top of the host cluster that you created.
Deleting Oracle Application Information
If you do not want the management server to monitor an Oracle instance, you can remove its
information, as described in the following steps:
1. Select Options > Protocol Settings > Storage Essentials > System Application Discovery Settings.
To select a target, you must have at least one element designated as a server, workstation or
desktop. If you see the message, “No Targets Currently Selected,” change your element from
unknown to either a server, workstation or desktop. See the documentation for HP Systems
Insight Manager. Select a target, and then, click Run Now.
2. In the Database Information table, click the button, corresponding to the Oracle Application
instance you do not want the management server to monitor.
3. Perform Discovery Data Collection to make the management server aware of your changes.