Installation Manual

HP Storage Essentials SRM 6.0 Installation Guide 395
3. To create a new certificate containing the DNS name of the management server, enter the
following at the command prompt:
%MGR_DIST%
\Tools> generateAppiqKeystore.bat
4. If the program is unable to detect a DNS name, enter the following at the command prompt:
%MGR_DIST%
\Tools> generateAppiqKeystore.bat mycomputername
where mycomputername is the DNS name of the computer
5. To copy the new certificate to the management server, enter the following at the command
prompt:
%MGR_DIST%
\Tools> generateAppiqKeystore.bat copy
The new certificate is copied to the correct location.
and Linux
To change the certificate on and Linux:
1. Go to the [Install_Dir] directory and run the following command:
eval ‘./usersvars.sh‘
IMPORTANT: The quotes in the example must be entered as left single quotes as shown.
2. Go to the following directory:
[Install_Dir]/Tools
where [Install_Dir] is the directory into which you installed the management server.
3. To delete the original certificate, enter the following at the command prompt:
perl generateAppIQKeyStore.pl del
The original certificate is deleted.
NOTE: If you see an error message when you enter this command, a previous certificate
may not have been created. You can ignore the error message.
4. To create a new certificate containing the DNS name of the management server, enter the
following at the command prompt:
perl generateAppIQKeyStore.pl
5. If the program is unable to detect a DNS name, enter the following at the command prompt:
perl generateAppIQKeyStore.pl create mycomputername
where mycomputername is the DNS name of the computer
6. To copy the new certificate to the management server, enter the following at the command
prompt:
perl generateAppIQKeyStore.pl copy
The new certificate is copied to the correct location.
Troubleshooting Discovery and Discovery Data Collection
This section contains the following topics: