Command Reference Guide

2.4 NAME 22
2.4 NAME
fsecheck – Perform a File System Catalog consistency check against the HSM file
system or FSE media.
2.4.1 SYNOPSIS
fsecheck {–i | – –fsc–hsmfs} PartitionName
fsecheck {–m | – –fsc–media} [––autocorrect [– –match–media]] Partition-
Name
fsecheck {–h | – –help}
fsecheck {–v | – –version}
2.4.2 DESCRIPTION
Each FSE command communicates with the FSE system components through the
Management Interface (fse–mif). To execute an FSE command, the Management
Interface must be running. If the connection to the Management Interface fails,
check its status by running the fse status command. In case the Management
Interface is not running, start it with the fse start command.
After a successful command execution fsecheck notifies the FSE administrator
with a suitable message, which is printed to the standard output stream (stdout).
If there was an error during the command execution, an appropriate error message
is printed to the standard error stream (stderr).
CHECKING CONSISTENCY OF THE FILE SYSTEM CATALOG
fsecheck command creates a maintenance job on the specified FSE partition.
The maintenance job is executed by the corresponding Partition Manager and
performs a File System Catalog consistency check. This is a process of com-
paring file entries, which are present in File System Catalog, either with files on
the corresponding HSM file system or with Fast Recovery Information (FRI) on
the corresponding FSE media. It detects the situations, where:
• some files on the HSM file system or on the FSE media are missing from
File System Catalog,
File System Extender 3.2 Command Line Reference