User's Manual

Factory default: WY50+
This specifies the particular terminal to emulate, as supported by Wyse WY-50/50+/60 terminals.
Select from the following:
◦
ADDS A2
Provides compatibility with software designed to drive the ADDS Viewpoint A2 terminal, as
emulated by the Wyse WY-50/50+/60 terminals.
◦
HZ 1500
Provides compatibility with software designed to drive the Hazeltine 1500 terminal, as
emulated by the Wyse WY-50/50+/60 terminals.
◦
Stratus V102
Provides compatibility with software designed to drive the Stratus V102 terminal.
◦
TVI910, TVI920 and TVI925
Provide compatibility with software designed to drive the TeleVideo 910+, 920 and 925
terminals, respectively, as emulated by the Wyse WY-50/ 50+/60 terminals.
◦
TVI950 and TVI955
Provide compatibility with software designed to drive the TeleVideo 950 and 955 terminals,
respectively.
◦
WY50, WY50+ and WY60
Provide compatibility with software designed to drive the Wyse WY-50, WY-50+ and
WY-60 terminals, respectively.
◦
Wyse PCTerm
Provides compatibility with software designed for the PC Term personality supported by
Wyse.
●
Font
Factory default: Courier New
This enables you to specify the font to use for displaying characters. The available settings depend
on the fonts installed on your system.
●
Character set
Factory default: Ascii
This specifies the character set used for displaying characters.
●
Ansi codepage
Factory default: PC Multinational (437)
This option determines the set of characters that form the second half of the multinational character
set when in multinational mode.
●
Multiple page
Factory default: Checked
224 Chapter 20 Wyse Emulations