User's Manual

Factory default: Checked
When this option is checked, TeemTalk will recognize an additional set of Wyse codes which are
not normally supported by specific non-Wyse terminals.
●
Answerback
Factory default: Unspecified
This enables you to specify the Answerback string that is sent to the host in response to an ANSI
mode enquiry command. The string may be up to 30 characters long.
●
Answerback concealed
Factory default: Unchecked
Checking this option will cause the Answerback string specified in the text box above to be locked
from change and displayed as asterisks. Note that unchecking this option will cause the
Answerback string to be deleted.
●
Answerback mode
Factory default: Unchecked
This option applies to all emulations and specifies whether or not an answerback message is
automatically sent to the host in response to an ASCII ENQ character.
●
Send ACK
Factory default: Checked
This option applies to all emulations and specifies whether or not an ASCII ACK character is sent
to the host port after certain commands have been executed.
●
Colour support
Factory default: Unchecked
When this option is checked, an additional set of host commands will be recognized to determine
the colors used for the display. Wyse 350 color commands will be recognized in all modes except
Wyse 60, which will use Wyse 60 color commands.
●
Application key mode
Factory default: Unchecked
When application key mode is selected, the function keys and certain editing keys will send
application codes when pressed, regardless of whether or not the keys have been redefined.
When this option is not selected, the keys will send their programmed definitions.
●
CR = CR/NULL
Factory default: Checked
This option allows you to disable the NULL being automatically sent on CR.
●
Block mode
Factory default: Unchecked
Setup Options
231