User's Manual

6-52
Setup Menus
Selecting End on Non-Hex enables you to specify the number of characters that make
up the end sequence in the End Length box. The bypass will then terminate as soon as
a non-hexadecimal character is received (any character except in the range 0 through 9
and A through F) followed by the end sequence.
Characters can be entered in several ways. For example, to specify the ASCII escape
character, you can enter either _027, \u001B, \e, \033, or even ^[.
Font
This enables you to specify the font to be used for displaying characters. The available
settings depend on the fonts installed.
Telnet Options
Clicking the Telnet Options button will display a dialog box with additional options.
These are described in the Getting Started chapter.
National Character Settings & APL2
This enables you to select the character set to be used. The IDs of the code page,
character set and CCSID used for the currently selected language are displayed under
the User Specified button. Clicking User Specified will display a dialog box that
enables you to change these settings.
There are separate Code Page, Character Set and CCSID entries for the Single Byte
Character Set (SBCS) and, if supported, Double Byte Character Set (DBCS). These
should only be changed by the System Administrator. If they have been changed and
you wish to restore the default settings, click the Default button in the IBM 3270
Settings dialog box. The following table shows the default settings.