User's Manual

C-56
Host Command Summary
LOADING CHARACTER SETS
Assign name to set currently selected for loading L(A ' set name ')
Select set for loading & assign name L(A set number ' set name ')
Select specified character set for loading L(A set number )
Specify character form in hex codes &
ASCII reference character L' ascii char ' hex codes
POSITION SELECTION
Select active position & move cursor to it P[ coordinates ]
Specify position to move to via a PCV
using PCV active only for current command P(W(M pcm )) pcv
Specify series of positions to move to. Post-
command active position = last specified position P(S) positions & options (E)
Specify series of positions to move to. Post-command
active position = pre-command active position P(B) positions & options (E)
Specify writing with first bit of pattern P[]
REQUESTING REPORTS
Request report of active position R(P)
Request report of command set stored
for specified character R(M( character ))
Request report of last detected error R(E)
Request report of name assigned to char.
set currently selected for loading R(L)
Request report of total & remaining space
available for storage of command sets R(M(=))
Select GIN mode R(P(I)
SCREEN SETTING
Select display addresing range S(A[ coords ][ coords ]
Scroll from specified coordinates S[ coordinates ]
Scroll from specified position S(W(M pcm )) pcv
Define hardcopy region S(H positions )
Specify printed image offset S(H( positions )
Specify output map location lightness
value (monochrome monitor) S(M location (lightness ))
Specify output map location RGB character S(M location ( rgb character ))
Specify output map location HLS colour val. S(M location ( hls values ))
Select specifed output map location
colour for background S(I location )
Select output map location colour approx.
specified RGB character for background S(I( rgb character ))
Select output map location colour approx.
specified HLS values for background S(I( hls values ))
Erase screen to current background S(E)
Erase screen to specified background S(I location ,E)
Specify time delay before command S(T time )
Control cursor display S(C control value )
Set temporary writing controls S(W( sub-options ))