User's Manual

C-83
Host Command Summary
Wyse Emulations
ATTRIBUTES
Assign character display attribute ESC G *attribute
Assign line attribute ESC G *line attribute
Assign write-protected character attribute ESC ' *attribute
Line attribute mode on ESC e 3
Page attribute mode on ESC e 2
Wyse 60 character attribute mode on ESC e 1
Wyse 60 character attribute mode off ESC e 0
CHARACTER SETS (WY-60 only)
Define & load soft character ESC c A *b *p *...*c CTRL Y
*b = bank 0-3, *p = position in character set (2-byte hex)
*...*c = character bit pattern (32-byte character string)
Automatic font loading enabled ESC e O
Automatic font loading disabled ESC e N
Load font bank with predefined character set ESC c @ *bank *set
Bank: 0 = Bank 0, 1 = Bank 1, 2 = Bank 2, 3 = Bank 3
Set: Native mode @ Standard ANSI G
Multinational A 44-line Native mode '
Standard ASCII B 44-line Multinational a
Graphics 1 C 44-line PC Equivalent b
PC Equivalent D 44-line Standard ASCII c
Graphics 2 E 44-line Standard ANSI d
Graphics 3 F
Clear font bank (* = 0 - 3) ESC c ? *
Specify font bank for primary character set (* = 0 - 3) ESC c B *
Specify font bank for secondary character set (* = 0 - 3) ESC c C *
Select primary character set for display ESC c D
Select secondary character set for display ESC c E
CLEARING DATA
Clear cursor column ESC V
Clear entire rectangle in 80 column page ESC c H *line *col *character
Clear entire rectangle in 132 column page ESC c H *line ~ *col *character
Clear page to nulls ESC *
Clear page to spaces ESC +
Clear page to write-protected spaces ESC ,
Clear unprotected column to nulls ESC c K
Clear unprotected column to specified character ESC c I *character
Clear unprotected line to nulls from cursor ESC t
Clear unprotected line foreground to nulls from cursor ESC c S
Clear unprotected line to spaces from cursor ESC T
Clear unprotected line foreground to spaces from cursor ESC c R
Clear unprotected page to attribute character ESC !