User's Manual

Print By Pass Settings
●
Start Sequence
Factory default: Unspecified
This enables you to enter the character or sequence of characters that initiate a print bypass.
Characters can be entered in several ways. For example, to specify the ASCII escape character,
you can enter either _027, \u001B, \e, \033, or even ^[.
●
By Pass End Method
Factory default: Specify Sequence
You can select from the following print bypass methods: Specify Sequence, Count in Header
or End on Non-Hex.
●
End Sequence
Factory default: Unspecified
When the print bypass method is set to Specify Sequence, this enables you to specify the end
sequence.
End sequence characters can be entered in several ways. For example, to specify the ASCII
escape character, you can enter either _027, \u001B, \e, \033, or even ^[.
When an end sequence is specified, characters in the data stream between the start and end are
interpreted as encoded ASCII. For example, 1B0A becomes ASCII 27 10 (ESC LF).
If no end sequence is specified, the bypass is assumed to be for a single pair of characters only.
●
Length of End Sequence
Factory default: 0
170 Chapter 16 IBM 3270 Printer Emulation