User's Manual

4. You can configure the transport, connection and emulation settings by selecting the relevant
Configure options in the Session menu. The options displayed by selecting Configure
emulation are described in the section
Setup Options on page 210.
5. To save the session, display the File menu and select Save session as. In the File Name field,
enter a unique name that will identify this session configuration for future selection, then click
Save. Note that session files have the filename extension .tts.
6. To run the session, display the File menu and select Open Session. Select the name of the .tts
session file then click Open.
Operating Modes
The Tandem 6530 emulation operates in one of three main modes: Conversational, Block, or ANSI.
Conversational and Block modes are normally used for applications running on a NonStop host system.
ANSI mode is for applications running on the LXN host system.
Conversational mode
In Conversational mode, characters are sent to the host as you type them. This is useful when
applications need to interact with you on a character, word or line-by-line basis.
Display memory is treated as one long page consisting of 400 lines, of which 24 lines may be viewed
at any one time. Lines above or below those currently displayed may be scrolled into view using cursor
or display control keys. Once all the display memory has been used, new data will force all previous
lines of data up one line so that the first line is erased, ensuring that the oldest data is erased first.
The status line will display CONV when you are in Conversational mode.
Block Mode
In Block mode, characters are stored in a communications buffer and are not transmitted to the host
until the application requests them. The characters are then sent as a block. This enables you to enter a
large amount of data and edit it locally before it is transmitted.
Block mode has two sub-modes: Block Nonprotect and Block Protect. In Block Nonprotect mode you
can enter any type of character at any position on the screen (except on the 25th line). In Block Protect
mode the application divides the screen into protected and nonprotected areas called fields. The cursor
cannot be moved into protected fields, which may contain prompts or information or be empty. The
cursor can only be moved into unprotected fields, which may also define the type of characters that can
be entered.
In Block mode, display memory is divided into pages, the number of pages being determined by the
application.
The status line will display BLOCK when you are in Block mode, and PROT when in Block Protect
mode.
ANSI Mode
In ANSI mode, characters are sent to the host as you type them, and standard ANSI (American
National Standard Institute) functions are executed. Applications that run on the LXN host system
generally recognize and use these functions.
206 Chapter 19 TA6530 Emulation