User's Manual

Specify the settings required by the host using the options described below, then click the Connect
button.
●
Communications Port
Factory default: COM3
This specifies the port used to communicate with the host.
●
Baud Rate
Factory default: 9600
Specifies the connection speed in the range 110 to 115200 baud.
●
Parity
Factory default: None
This option specifies the parity mode for each transmitted character. If the number of data bits
specified by Word Length is 8, set this option to None.
Selecting Odd will cause an eighth bit to be added with a value of 1 if the previous 7 bits add up
to an even number, and 0 if the previous 7 bits add up to an odd number. Selecting Even will
cause an eighth bit to be added with a value of 1 if the previous 7 bits add up to an odd number,
and 0 if the previous 7 bits add up to an even number. Mark parity will set every eighth bit to 1
and Space parity every bit to 0.
●
Word Length
Factory default: 8
This option specifies the number of data bits sent for each transmitted character.
●
Stop Bits
Factory default: 1
This specifies the number of stop bits sent for each transmitted character.
●
Flow Control
Factory default: Both
This option specifies the type of flow control used by the line port to communicate readiness to
transmit or receive data from the host.
Flow control setting Effect on flow control
None No flow control.
Input XON/XOFF on received data.
Output XON/XOFF on transmitted data.
Both XON/XOFF on transmitted and received
Hardware RTS/CTS hardware flow control.
●
Half Duplex
Factory default: Unchecked
Serial Transport
31