Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

8–6 HSG60 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

See the release notes for the version of the controller's software for information on which

drives can be supported.

CAUTION: Never initialize any container or this procedure will not protect data.

Use the following procedure to move a storageset, while maintaining the data the

storageset contains:

1. Show the details for the storageset you want to move. Use the following command:

SHOW STORAGESET-NAME

2. Label each member with its name and PTL location.

If you do not have a storageset map for the subsystem, you can enter the

LOCATE

command for each member to find its PTL location. Use the following command:

LOCATE DISK-NAME

To cancel the locate command, enter the following:

LOCATE CANCEL

3. Delete the unit number shown in the “Used by” column of the SHOW storageset-name

command. Use the following syntax:

DELETE UNIT-NUMBER

4. Delete the storageset shown in the “Name” column of the SHOW storageset-name

command. Use the following syntax:

DELETE STORAGESET-NAME

5. Delete each disk drive, one at a time, that the storageset contained. Use the following

syntax:

DELETE DISK-NAME

6. Remove the disk drives and move them to their new PTL locations.

7. Again add each disk drive to the controller's list of valid devices. Use the following

syntax:

ADD DISK DISK-NAME PTL-LOCATION