Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

5–14 HSG60 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide
For a description of why plugging in one adapter can result in multiple connections,
see “Numbers of Connections,” page 1–12.
14. Rename the connection(s) to something meaningful to the system and easy to
remember. For example, to assign the name ANGEL1A1 to connection !NEWCON01,
enter:
RENAME !NEWCON01 ANGEL1A1
Compaq recommends using a naming convention, see “Naming Connections,” page
1–12.
15. Specify the operating system for the connection:
SET ANGEL1A1 OPERATING_SYSTEM=TRU64_UNIX
16. Verify the changes:
SHOW CONNECTIONS
Mark or tag all Fibre Channel cables at both ends for ease of maintenance.
Repeat Procedure for Each Host Adapter
17. Repeat steps 14, 15, and 16 for each of that adapter’s host connections or delete the
unwanted connections from the table.
18. For each host adapter, repeat steps 13 through 17.
Verify Installation
To verify installation for your Tru64_UNIX host, enter one of the following commands:
For V4.0G Use
file /dev/rrx*c | grep HSG80
For V5.1x Use
file /dev/cport/ *
Your host computer should report one CCL device special file for each HSG60 configured.