Compaq StorageWorks HSG60 ACS Solution Software V8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Installing and Configuring the HS-Series Agent 4–9
Final System Configuration
26. Do one of the following:
❏ If you are running the Agent in cluster, select option y. The software is configured
to scan the SCSI-bus for subsystems at startup.
❏ If you are not running the Agent in a cluster, select option n. The software is
configured to look at the storage.ini file at startup time. The storage.ini file contains
the listing of your subsystems.
NOTE: Compaq recommends that if you are running Tru64 UNIX 5.1x, especially within a fabric,
configure the software to scan the SCSI-bus at startup. When asked if running the Agent in a
cluster, answer y.
The system starts the new Agent.
27. Enter the following and press the Enter key to unmount the CD-ROM:
# cd /
# umount /mnt
Reconfiguring the Agent
You can change your configuration using the SWCC Agent Configuration menu. To
access this menu, enter the following command:
# /usr/opt/SWCC510/scripts/swcc_config
The following is an example of the menu
.
SWCC Agent Configuration Utility
----------------------------------------
Options Available Are:
1) Add/Delete Client PC Information.
2) Modify Storage Subsystem Information.
3) Change SWCC Agent Password.
4) Turn Email Notification ON/OFF.
5) Add/Delete Email Notification Users.
6) Restart Agent With Changes.
7) Enable/Disable Agent.
8) Cluster/No Cluster
Enter a number or 'q' to QUIT: