HP Tru64 UNIX Release Notes for Version 5.1B-5 (AA-RVGEE-TE, March 2009)

You can correct this problem by installing the latest version of the Insight Manager,
Version 3.7. You can download this version from the HP Insight Management Agents
for Tru64 UNIX Web site:
http://h30097.www3.hp.com/cma/
If you have not installed Version 3.7 and the Insight Manager processes do not run
after you reboot your system, restart them using the Insight Manger startup scripts.
3.4.8 Autoloader Firmware Upgrade Changes WWID
A firmware upgrade to v1.50 or N14r on the 1x8 Autoloader causes the WWID to
change. As a result, the existing device associated with the media changer is no longer
accessible. For complete details see the Customer Advisory available at:
http://h30097.www3.hp.com/unix/erp/c00753663.html
3.4.9 Smart Array Booting Problem Might Require Service Call
If when booting your system you see a message similar to the following, rebooting
your system may be able to re-enable the hardware:
Smart Array at ciss(1) not responding - disabled.
If the reboot fails, call your HP service representative to have the unit repaired.
3.4.10 Do Not Use dxarchiver to Verify Bootable Tape
Do not use dxarchiver command to verify a bootable tape. Instead, use the mt and
restore commands as follows:
# mt fsf 1
# restore -i <device>
The first command skips the first file on the tape.
When preparing for a btcreate session, verify the size of the file system to ensure
that you have sufficient tape volumes, depending on the maximum storage capacity
of your tape device. The btcreate command prompts you to load a new tape volume
if it runs out of storage space. Label the tapes in sequence.
3.4.11 securenets File Requires localhost Entry
If the /var/yp/securenets file is in use as part of NIS, it must contain the following
localhost entry:
255.255.255.255 127.0.0.1
If the /var/yp/securenets file is used without a localhost entry, you will see severe
delays on logins. See ypserv(8) for more information.
3.4 General Release Notes 37